OIL AND OIL FILTER > REPLACEMENT |
| 1. REMOVE OIL FILTER ELEMENT SERVICE HOLE COVER |
![]() |
Remove the 3 clips.
![]() |
Pull the oil filter element service hole cover to open it.
![]() |
Using one of the removed clips, secure the service hole cover with it folded at a 180° angle.
| *1 | Clip |
| 2. DRAIN ENGINE OIL |
Remove the oil filler cap.
Remove the oil pan drain plug and gasket, and drain the oil into a container.
Clean and install the oil pan drain plug with a new gasket.
| 3. REMOVE OIL FILTER CAP ASSEMBLY |
![]() |
Using SST, loosen the oil filter cap 4 revolutions, align the cap ribs vertically, and drain the remaining engine oil in the oil filter cap.
| *1 | Cap Rib |
| *2 | Oil Filter Bracket Clip |
Remove the oil filter cap assembly.
![]() |
Remove the oil filter element and O-ring from the oil filter cap.
| *1 | Oil Filter Element |
| *2 | O-ring |
| 4. INSTALL OIL FILTER CAP ASSEMBLY |
Clean the oil filter cap threads and O-ring groove.
Apply a small amount of engine oil to a new O-ring and install it to the oil filter cap.
Set a new oil filter element in the oil filter cap.
Remove any dirt or foreign matter from the installation surface and inside of the engine.
![]() |
Reapply a small amount of engine oil to the O-ring of the oil filter cap assembly. Align the cutout in the oil filter cap threads 90° to the grooves in the oil filter bracket and temporarily tighten the cap.
![]() |
Using SST, tighten the oil filter cap assembly.
| *1 | No Clearance |
| *2 | Oil Filter Bracket Clip |
| 5. ADD ENGINE OIL |
Add new engine oil and install the oil filler cap.
| Oil Grade | Oil Viscosity (SAE) |
| API grade SL "energy-conserving", SM "energy-conserving", SN "resource-conserving" or ILSAC multigrade engine oil |
|
| API grade SL, SM or SN multigrade engine oil |
|
| Item | Standard Condition |
| Drain and refill with oil filter change | 4.2 liters (4.4 US qts, 3.7 lmp. qts) |
| Drain and refill without oil filter change | 3.9 liters (4.1 US qts, 3.4 lmp. qts) |
| Dry fill | 4.7 liters (5.0 US qts, 4.1 lmp. qts) |
| 6. INSPECT FOR ENGINE OIL LEAK |
Put the engine in inspection mode (Click here).
Start the engine.
Check for engine oil leaks from the connected parts of the oil filter cap and oil filter drain plug.
| 7. INSTALL OIL FILTER ELEMENT SERVICE HOLE COVER |
![]() |
Remove the clip.
| *1 | Clip |
![]() |
Close the service hole cover.
![]() |
Install the oil filter element service hole cover with the 3 clips.