Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for RHD)

BRAKE PEDAL (for RHD) > REMOVAL

for Preparation Click here



1. REMOVE UPPER INSTRUMENT PANEL ASSEMBLY

HINT:
Refer to the instructions for Removal of the upper instrument panel assembly (Click here).



2. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    B223634
  1. Remove the screw <D>.

  1. Disengage the 2 claws and guide.

  1. Disconnect each connector and remove the No. 1 instrument panel under cover sub-assembly.



3. REMOVE ECU INTEGRATION BOX RH


    C208065
  1. Disconnect the connectors.



    C208064
  1. Remove the nut, bolt and ECU integration box RH.



4. REMOVE BRAKE PEDAL STROKE SENSOR ASSEMBLY


    C208067
  1. Disconnect the sensor connector.



    C208066
  1. Remove the 2 nuts and brake pedal stroke sensor assembly.

    NOTICE:
    Do not drop the brake pedal stroke sensor assembly. If the brake pedal stroke sensor assembly has been dropped, replace the brake pedal stroke sensor assembly with a new one.



5. REMOVE STOP LIGHT SWITCH ASSEMBLY


    E189653
  1. Disconnect the connector.



    E189656
  1. Turn the stop light switch assembly counterclockwise and remove it.



6. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER


7. REMOVE BRAKE PEDAL RETURN SPRING


    C205656
  1. Remove the brake pedal return spring from the brake pedal support sub-assembly and push rod pin.



8. REMOVE PUSH ROD PIN


    C205657
  1. Remove the clip and push rod pin to separate the brake pedal sub-assembly from the push rod clevis.



9. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY


    C205654
  1. Remove the bolt and separate the brake pedal support assembly from the instrument panel reinforcement.



    C205660
  1. Disengage the 2 clamps.



    C205658
  1. Remove the 4 nuts and brake pedal support assembly.



    C209160
  1. Remove the nut from the brake pedal support assembly.