BRAKE PEDAL (for RHD) > REMOVAL |
| 1. REMOVE UPPER INSTRUMENT PANEL ASSEMBLY |
| 2. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
![]() |
Remove the screw <D>.
Disengage the 2 claws and guide.
Disconnect each connector and remove the No. 1 instrument panel under cover sub-assembly.
| 3. REMOVE ECU INTEGRATION BOX RH |
![]() |
Disconnect the connectors.
![]() |
Remove the nut, bolt and ECU integration box RH.
| 4. REMOVE BRAKE PEDAL STROKE SENSOR ASSEMBLY |
![]() |
Disconnect the sensor connector.
![]() |
Remove the 2 nuts and brake pedal stroke sensor assembly.
| 5. REMOVE STOP LIGHT SWITCH ASSEMBLY |
![]() |
Disconnect the connector.
![]() |
Turn the stop light switch assembly counterclockwise and remove it.
| 6. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER |
| 7. REMOVE BRAKE PEDAL RETURN SPRING |
![]() |
Remove the brake pedal return spring from the brake pedal support sub-assembly and push rod pin.
| 8. REMOVE PUSH ROD PIN |
![]() |
Remove the clip and push rod pin to separate the brake pedal sub-assembly from the push rod clevis.
| 9. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY |
![]() |
Remove the bolt and separate the brake pedal support assembly from the instrument panel reinforcement.
![]() |
Disengage the 2 clamps.
![]() |
Remove the 4 nuts and brake pedal support assembly.
![]() |
Remove the nut from the brake pedal support assembly.