BRAKE PEDAL (for LHD) > ADJUSTMENT |
| 1. INSPECT AND ADJUST BRAKE PEDAL HEIGHT |
Check the brake pedal height.
Turn back the carpet.
Turn back the dash silencer from the slit provided on the dash silencer.
![]() |
Measure the shortest distance between the brake pedal surface and floor panel.
| *1 | Stop Light Switch Assembly |
| *2 | Clevis Lock Nut |
| *3 | Floor Panel |
| *4 | Brake Pedal Height |
Adjust the brake pedal height.
Remove the stop light switch assembly (Click here).
Loosen the clevis lock nut.
Adjust the brake pedal height by turning the push rod.
Tighten the clevis lock nut.
Install and adjust the stop light switch assembly (Click here).
| 2. INSPECT AND ADJUST BRAKE PEDAL STROKE SENSOR ASSEMBLY |
When installing a new brake pedal stroke sensor assembly:
![]() |
Fully tighten a new brake pedal stroke sensor assembly with the 2 nuts.
Firmly depress the brake pedal and break the brake pedal stroke sensor assembly lever set pin.
Remove the broken lever set pin.
When reusing the brake pedal stroke sensor assembly:
Connect the cable to the negative (-) battery terminal.
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/ TRC / Data List.
![]() |
Reading the value of the brake pedal stroke sensor assembly shown in the Data List, turn the brake pedal stroke sensor assembly slowly to the right and left to adjust the output voltage to the standard voltage.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Stroke Sensor | Stroke sensor / min.: 0 V, max.: 5 V | 0.8 to 1.2 V | - |
Tighten the 2 nuts.
Turn the power switch off.
Disconnect the intelligent tester.
| 3. INSPECT BRAKE PEDAL FREE PLAY |
![]() |
Depress the pedal until a slight resistance is felt. Measure the brake pedal free play as shown in the illustration.
| *1 | Brake Pedal Free Play |
| 4. INSPECT BRAKE PEDAL RESERVE DISTANCE |
Release the parking brake pedal.
With the power switch on (READY), depress the brake pedal and measure the pedal reserve distance.