Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for LHD)

BRAKE PEDAL (for LHD) > REASSEMBLY

for Preparation Click here



1. INSTALL BRAKE PEDAL PAD


2. INSTALL BRAKE PEDAL BUSHING
  1. Apply lithium soap base glycol grease to 2 new brake pedal bushings.

  1. Install the 2 brake pedal bushings to the brake pedal sub-assembly.



3. INSTALL BRAKE PEDAL SHAFT COLLAR
  1. Install the brake pedal shaft collar to the brake pedal sub-assembly.



4. INSTALL BRAKE PEDAL SUB-ASSEMBLY


    C205692
  1. Install the brake pedal sub-assembly to the brake pedal support sub-assembly with the brake pedal shaft and nut.

    Torque:
    17 N*m{ 176 kgf*cm , 13 ft.*lbf }



5. INSTALL BRAKE PEDAL STROKE SENSOR ASSEMBLY

NOTICE:
Do not drop the brake pedal stroke sensor assembly. If the brake pedal stroke sensor assembly has been dropped, replace the brake pedal stroke sensor assembly with a new one.



  1. When installing a new brake pedal stroke sensor assembly:

    NOTICE:
    Do not break the brake pedal stroke sensor assembly lever set pin before installing the brake pedal stroke sensor assembly with the nuts.




      C208061E02
    1. Temporarily install a new brake pedal stroke sensor assembly with the 2 nuts.
      Text in Illustration 
      *1
      Brake Pedal Groove
      *2
      Brake Pedal Stroke Sensor Assembly Lever

      NOTICE:
      1. Engage the brake pedal stroke sensor assembly lever with the brake pedal groove.
      2. Check that there is no foreign matter attached to the contact surface of the brake pedal stroke sensor assembly.
      3. Check that the tip of the brake pedal stroke sensor assembly lever is protruding from the brake pedal groove.



  1. When reusing the brake pedal stroke sensor assembly:



      C208061E02
    1. Temporarily install the brake pedal stroke sensor assembly with the 2 nuts.
      Text in Illustration 
      *1
      Brake Pedal Groove
      *2
      Brake Pedal Stroke Sensor Assembly Lever

      NOTICE:
      1. Engage the brake pedal stroke sensor assembly lever with the brake pedal groove.
      2. Check that there is no foreign matter attached to the contact surface of the brake pedal stroke sensor assembly.
      3. Check that the tip of the brake pedal stroke sensor assembly lever is protruding from the brake pedal groove.