Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR OPENER SWITCH

BACK DOOR OPENER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT BACK DOOR OPENER SWITCH ASSEMBLY


  1. Check the operation of the opener switch.


    B171359E15


    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      2 (E) - 3 (UL)
      Back door opener switch not pushed
      10 kΩ or higher
      2 (E) - 3 (UL)
      Back door opener switch pushed
      Below 1 Ω


      Text in Illustration 
      *1
      Component without harness connected
      (Back Door Opener Switch Assembly (Opener Switch))
      *2
      w/o Entry System Back Door Open Function
      *3
      w/ Entry System Back Door Open Function
      -
      -
      If the result is not specified, replace the back door opener switch assembly.



  1. Check operation of the lock switch (w/ Entry System Back Door Open Function).



      B171360E03
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Position
      Specified Condition
      1(L) - 2(E)
      Back door lock switch not pushed
      10 kΩ or higher
      1(L) - 2(E)
      Back door lock switch pushed
      Below 1 Ω

      Text in Illustration 
      *1
      Component without harness connected
      (Back Door Opener Switch Assembly (Lock Switch))
      If the result is not specified, replace the back door opener switch assembly.