Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR OPENER SWITCH

BACK DOOR OPENER SWITCH > REMOVAL

for Preparation Click here



1. REMOVE BACK DOOR TRIM BOARD ASSEMBLY


    B227899
  1. Using a moulding remover, disengage the clip and claw.



    B227900
  1. Using a moulding remover, disengage the clip and claw.



    B257325E01
  1. Disengage the 3 clips in the order shown in the illustration.



    B257326
  1. Disengage the 2 clips by pulling the back door trim board assembly in the direction indicated by the arrows in the illustration.



    B257327E01
  1. Remove the back door trim board assembly by pulling it in the direction indicated by the arrow in the illustration to disengage the 4 clips.
    Text in Illustration 
    *1
    Back Door Trim Board Assembly
    *2
    Back Door Panel
    *a
    The portion that may be damaged due to interference

    NOTICE:
    Make sure to pull the back door trim board assembly in the direction indicated by the arrow in the illustration. If the back door trim board assembly is removed from the lower part, the door pull handle mounting area may interfere with the back door panel, resulting in damage to the back door trim board assembly.



2. REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY


    B229356E01
  1. Put protective tape around the back door outside garnish sub-assembly.
    Text in Illustration 
    *1
    Protective Tape



    B229355
  1. Remove the 4 nuts.



    B229357
  1. Disengage the 11 clips and remove the back door outside garnish sub-assembly.

  1. Remove the 11 clips (back door outside garnish clip) from the back door outside garnish sub-assembly.

  1. Remove the 4 gaskets from the back door outside garnish sub-assembly.



3. REMOVE BACK DOOR OPENER SWITCH ASSEMBLY


    B227912
  1. Remove the back door opener switch assembly.