REAR WIPER MOTOR > INSTALLATION |
| 1. INSTALL REAR WIPER MOTOR ASSEMBLY |
![]() |
Install the rear wiper motor assembly with the 3 bolts.
Connect the connector.
| 2. INSTALL BACK DOOR TRIM BOARD |
![]() |
Engage the 5 clips and 2 guides to install the back door trim board.
| 3. INSTALL BACK DOOR TRIM BOARD ASSEMBLY |
![]() |
Engage the 11 clips and 2 claws to install the back door panel trim assembly.
| 4. INSTALL BACK DOOR SIDE GARNISH LH |
![]() |
Engage the 3 clips and 2 claws to install the back door side garnish LH.
| 5. INSTALL BACK DOOR SIDE GARNISH RH |
![]() |
Engage the 3 clips and 2 claws to install the back door side garnish RH.
| 6. INSTALL UPPER BACK DOOR TRIM PANEL ASSEMBLY |
![]() |
Engage the 4 clips and 4 claws to install the upper back door trim panel assembly.
| 7. INSTALL REAR WIPER MOTOR GROMMET |
![]() |
Apply MP grease to the entire surface of the rear wiper motor grommet lip.
| *1 | MP grease |
![]() |
Install the rear wiper motor grommet.
| *1 | Alignment Mark |
| 8. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY |
Operate the wiper and stop the windshield wiper motor at the automatic stop position.
When reusing the rear wiper arm and blade assembly:
![]() |
Clean the wiper arm serrations.
| *1 | Wiper Arm Serration |
When reusing the rear wiper motor assembly:
![]() |
Clean the wiper pivot serrations with a wire brush.
| *1 | Wire Brush |
| *2 | Wiper Pivot Serration |
![]() |
Install the rear wiper arm and blade assembly with the nut to the position shown in the illustration.
| *1 | Ceramic Dot |
Operate the rear wiper while spraying washer fluid onto the back door glass. Make sure that the rear wiper functions properly and the wiper does not come into contact with the vehicle body.
w/ Steel Wiper Arm:
Close the rear wiper arm head cap.
| 9. INSTALL REAR WIPER ARM HEAD CAP (w/ Resin Wiper Arm) |
![]() |
Engage the 2 claws to install the rear wiper arm head cap.
![]() |
Engage the 2 claws to close the rear wiper arm head cap as shown in the illustration.