Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR (for Rear Side)

WASHER MOTOR (for Rear Side) > INSPECTION

for Preparation Click here



1. INSPECT REAR WASHER MOTOR AND PUMP ASSEMBLY
  1. Remove the washer jar.

  1. Disconnect the rear washer motor and pump connector.

    HINT:
    The check should be performed with the rear washer motor and pump installed on the washer jar.

  1. Fill the washer jar with washer fluid.



    E140350E02
  1. Connect a battery positive (+) lead to terminal 1 of the rear washer motor and pump, and a negative (-) lead to terminal 2.

  1. Check that washer fluid flows from the washer jar.

    OK:
    Washer fluid flows from the washer jar.

    Text in Illustration 
    *1
    Component without harness connected
    (Rear Washer Motor and Pump Assembly)
    If the result is not as specified, replace the rear washer motor and pump assembly.