POWER STEERING ECU > INSTALLATION |
| 1. INSTALL POWER STEERING ECU ASSEMBLY |
![]() |
Install the power steering ECU assembly with the bolt and 2 nuts.
![]() |
Connect the 3 connectors to the power steering ECU assembly.
![]() |
Connect the connector to the power steering ECU assembly.
| *1 | Lock Lever |
| *2 | Lock of the Lock Lever |
Engage the wire harness clamp to the power steering ECU assembly.
| 2. INSTALL UPPER INSTRUMENT PANEL ASSEMBLY |
| 3. ROTATION ANGLE SENSOR INITIALIZATION AND TORQUE SENSOR ZERO POINT CALIBRATION |
Clear the rotation angle sensor calibration value, initialize the rotation angle sensor, and calibrate the torque sensor zero point (Click here).
| 4. ASSIST MAP WRITING |
Perform assist map writing (Click here).