Home › Vehicle Exterior › DOOR / HATCH › HOOD

HOOD > REASSEMBLY

for Preparation Click here



1. INSTALL HOOD STAY BRACKET


    B227881
  1. Install the hood stay bracket with the bolt.



2. INSTALL HOOD SUPPORT ROD


    B227880
  1. Engage the 3 claws and install the hood support rod.



3. INSTALL HOOD STAY HOLDER


    B227879
  1. Engage the 2 claws and install the hood stay holder.



4. CONNECT WASHER HOSE ASSEMBLY


    B227878
  1. Engage the 6 clips and connect the washer hose assembly.



5. INSTALL WASHER NOZZLE SUB-ASSEMBLY


    E189326
  1. Connect a new washer nozzle sub-assembly to the washer hose.



    E189324E01
  1. Engage the 2 claws and install the washer nozzle sub-assembly as shown in the illustration.



6. INSPECT WASHER NOZZLE SUB-ASSEMBLY


  1. With the engine running, check the position that the washer fluid hits the windshield.

    Standard:
    Washer fluid hits the windshield in the areas shown in the illustration.



    E214571E01


    Standard Clearance 
    Area
    Measurement
    Area
    Measurement
    A
    95.8 mm (3.77 in.)
    B
    323.6 mm (1.06 ft.)
    C
    161.4 mm (6.35 in.)
    D
    155.7 mm (6.13 in.)
    E
    443.7 mm (1.46 ft.)
    F
    546.6 mm (1.79 ft.)
    G
    208.2 mm (8.20 in.)
    H
    82.1 mm (3.23 in.)

    Text in Illustration 
    *1
    Upper Limit
    *2
    Standard
    *3
    Lower Limit
    -
    -

    HINT:
    If the result is not as specified, replace the malfunctioning washer nozzle sub-assembly.



7. ADJUST WASHER NOZZLE SUB-ASSEMBLY


  1. Select a washer nozzle so that the contact area is within the standard. Replace the washer nozzle with the selected one.


    E189325E01



8. INSTALL HOOD INSULATOR


    B227877
  1. Install the hood insulator with the 6 clips.



9. INSTALL HOOD AUXILIARY CATCH HOOK ASSEMBLY


    B227876
  1. Install the hood auxiliary catch hook assembly with the 2 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }