Home › Vehicle Exterior › WIPER / WASHER › RAIN SENSOR

RAIN SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT RAIN SENSOR


    E169141E07
  1. Disconnect the U11 rain sensor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    U11-1 (ES) - Body ground
    Always
    Below 1 Ω

    If the result is not as specified, repair or replace the harness or connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    U11-4 (SIG) - Body ground
    Power switch on (IG)
    11 to 14 V

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Rain Sensor)
    If the result is not as specified, repair or replace the harness or connector.



    E141656E11
  1. Reconnect the rain sensor connector.

  1. Connect an oscilloscope to the rain sensor connector.

  1. Check for pulses.

    OK:
    Tester Connection
    Condition
    Specified Condition
    U11-3 (AUTO) - U11-1 (ES)
    Power switch on (IG)
    Pulse generation

    Text in Illustration 
    *1
    Component with harness connected
    (Rain Sensor)
    If the result is not as specified, replace the rain sensor.