Home › Engine / Hybrid System › 2ZR-FXE ENGINE CONTROL › AIR FUEL RATIO SENSOR

AIR FUEL RATIO SENSOR > REMOVAL

for Preparation Click here



1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
  1. Remove the windshield wiper motor and link (Click here).



2. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)


    C205696
  1. Disengage the clamp and separate the wire harness.



    C209148
  1. Disengage the claw and bend the No. 1 heater air duct splash shield seal.



    C209146
  1. Disengage the claw and bend the water guard plate RH.



    C209144
  1. Remove the 9 bolts and outer cowl top panel sub-assembly.



3. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)


    C205556
  1. Disengage the clamp and separate the wire harness from the outer cowl top panel sub-assembly.



    C205555E01
  1. Disengage the clamp*1 and disconnect the connector (w/ Windshield Deicer).

  1. Disengage the clamp*2 and separate the wire harness from the outer cowl top panel sub-assembly.



    C205558
  1. Disengage the claw and bend the No. 1 heater air duct splash shield seal.



    C205560
  1. Disengage the claw and bend the water guard plate RH.



    C205557
  1. Remove the 9 bolts and outer cowl top panel sub-assembly.



4. REMOVE NO. 2 CYLINDER HEAD COVER


    A213020
  1. Remove the 3 clips and No. 2 cylinder head cover.

    NOTICE:
    1. Attempting to disengage both front and rear clips at the same time may cause the cover to break.
    2. Pull the cover straight up to remove. Attempting to pull the cover forward may cause it to break.

    NOTICE:
    Attempting to disengage both front and rear clips at the same time may cause the cover to break.



5. REMOVE AIR FUEL RATIO SENSOR


    A212298
  1. Disconnect the air fuel ratio sensor connector and clamp.



    A216699E01
  1. Using SST, remove the air fuel ratio sensor.

    SST
    09224-00010