Home › Engine / Hybrid System › 2ZR-FXE ENGINE CONTROL › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL HEATED OXYGEN SENSOR


    A212296E01
  1. Using SST, install the heated oxygen sensor onto the front exhaust pipe.
    Text in Illustration 
    *1
    Fulcrum Length
    300 mm
    *2
    Fulcrum Length
    30 mm

    SST
    09224-00010  

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    NOTICE:
    1. This torque value can be obtained by using a torque wrench with a fulcrum length of 300 mm (11.81 in.) and SST with a length of 30 mm (1.18 in.) (Click here).
    2. This torque value is effective when SST is parallel to the torque wrench.



    A212297
  1. Connect the wire harness to install the wire harness clamp bracket.



    A212294
  1. Install the wire harness clamp bracket with the bolt.

    Torque:
    12 N*m{ 127 kgf*cm , 9 ft.*lbf }

  1. Install the wire harness bracket.

  1. Connect the heated oxygen sensor connector.



2. INSPECT FOR EXHAUST GAS LEAK


3. INSTALL NO. 2 ENGINE UNDER COVER


    A212293
  1. Install the No. 2 engine under cover with the 4 clips.