Home › Engine / Hybrid System › 2ZR-FXE ENGINE CONTROL › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here


HINT:
Although the part name refers to the No. 1 crank position sensors, this procedure is for the camshaft position sensors.



1. INSTALL NO. 1 CRANK POSITION SENSOR


    A158220
  1. Apply a light coat of engine oil to the O-rings on the No. 1 crank position sensors.



    A216700E01
  1. Install the No. 1 crank position sensor with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Connect the No. 1 crank position sensor connector.



2. INSPECT FOR OIL LEAK


3. INSTALL NO. 2 CYLINDER HEAD COVER


    A213020
  1. Engage the 3 clips to install the cover.

    NOTICE:
    1. Be sure to engage the clips securely.
    2. Do not apply excessive force or hit the cover to engage the clips. This may cause the cover to break.