Home › Engine / Hybrid System › 2ZR-FXE ENGINE CONTROL › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here


HINT:
Although the part name refers to the No. 1 crank position sensors, this procedure is for the camshaft position sensors.



1. REMOVE NO. 2 CYLINDER HEAD COVER


    A213020
  1. Remove the 3 clips and No. 2 cylinder head cover.

    NOTICE:
    1. Attempting to disengage both front and rear clips at the same time may cause the cover to break.
    2. Pull the cover straight up to remove. Attempting to pull the cover forward may cause it to break.

    NOTICE:
    Attempting to disengage both front and rear clips at the same time may cause the cover to break.



2. REMOVE NO. 1 CRANK POSITION SENSOR


    A216700E01
  1. Disconnect the No. 1 crank position sensor connector.

  1. Remove the bolt and No. 1 crank position sensor.