STEERING WHEEL > INSTALLATION |
| 1. INSTALL LOWER STEERING WHEEL BOSS COVER |
![]() |
Engage the 2 pins and 4 claws to install the lower steering wheel boss cover to the steering wheel sub-assembly.
| 2. INSTALL CRUISE CONTROL SWITCH WIRE |
| 3. INSTALL CRUISE CONTROL MAIN SWITCH |
![]() |
Install the cruise control main switch with the 2 screws.
![]() |
Connect the connector.
| 4. INSTALL STEERING PAD SWITCH ASSEMBLY |
![]() |
Engage the 2 claws to install the steering pad switch assembly (RH side) to the steering wheel sub-assembly.
Install the 2 screws.
![]() |
Engage the 2 claws to install the steering pad switch assembly (LH side) to the steering wheel sub-assembly.
Install the 2 screws.
Connect the steering pad switch connector to the spiral cable sub-assembly.
| 5. INSTALL STEERING SHAKE DAMPER |
![]() |
Install the steering shake damper to the steering wheel assembly with the 2 screws.
| 6. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD |
| 7. ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY |
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Rotate the spiral cable counterclockwise slowly by hand until it stops.
![]() |
Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.
| *1 | Alignment Mark |
| 8. INSTALL STEERING WHEEL ASSEMBLY |
![]() |
Align the matchmarks on the steering wheel assembly and steering main shaft.
| *1 | Matchmark |
Install the steering wheel assembly set nut.
Connect the connectors to the spiral cable sub-assembly.
| 9. CHECK STEERING WHEEL CENTER POINT |
| 10. INSTALL STEERING PAD |