STEERING ANGLE SENSOR > REMOVAL |
| 1. PRECAUTION |
| 2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD |
| 3. REMOVE STEERING PAD |
| 4. REMOVE STEERING WHEEL ASSEMBLY |
![]() |
Remove the steering wheel assembly set nut.
| *1 | Matchmark |
Put matchmarks on the steering wheel assembly and steering main shaft.
Disconnect the connectors from the spiral cable.
![]() |
Using SST, remove the steering wheel assembly.
| *1 | Turn |
| *2 | Hold |
| 5. REMOVE LOWER STEERING COLUMN COVER |
![]() |
Push the right and left sides of the lower steering column cover to disengage the 4 claws.
![]() |
Insert fingers into the opening of the tilt lever of the lower steering column cover to disengage the 2 claws.
Using a screwdriver, insert the tip into each service hole to disengage the 2 claws to remove the lower steering column cover as shown in the illustration.

| *1 | Service Hole | *2 | Protective Tape |
| 6. REMOVE UPPER STEERING COLUMN COVER |
![]() |
Disengage the 2 claws and 2 pins to remove the upper steering column cover.
| 7. REMOVE SPIRAL CABLE WITH STEERING ANGLE SENSOR |
Remove the spiral cable with steering angle sensor .