FRONT BUMPER > INSTALLATION |
| 1. INSTALL FRONT BUMPER ASSEMBLY |
Connect the headlight cleaner hose. (w/ Headlight Cleaner System)
Connect each connector.
![]() |
Install the front bumper assembly as shown in the illustration.
![]() |
Engage the 3 claws to install the front bumper assembly.
![]() |
Engage the 2 guides and install the front spoiler cover. (w/ Front Spoiler)
Install the 2 clips and 2 screws. (w/ Front Spoiler)
![]() |
Install the 7 clips.
Install the 2 bolts and 4 screws.
![]() |
Install the screw.
![]() |
Install the pin hold clip.
| 2. INSTALL RADIATOR SUPPORT OPENING COVER |
![]() |
Engage the 2 claws and install the radiator support opening cover.
Install the 3 clips.
| 3. ADD WASHER FLUID (w/ Headlight Cleaner System) |
Add washer fluid to the washer jar.
| 4. PREPARE VEHICLE FOR FOG LIGHT AIM ADJUSTMENT |
Prepare the vehicle:
| 5. PREPARE FOR FOG LIGHT AIMING |
![]() |
Prepare the vehicle (except Taiwan):
![]() |
Prepare the vehicle (for Taiwan):
Prepare a piece of thick white paper (approximately 2 m (6.6 ft.) (height) x 4 m (13.1 ft.) (width)) to use as a screen.
Draw a vertical line down the center of the screen (V line).
Set the screen as shown in the illustration (except Taiwan).

Set the screen as shown in the illustration (for Taiwan).

![]() |
Draw base lines (H, V LH, and V RH lines) on the screen as shown in the illustration.
H Line (Fog light height):
Draw a horizontal line across the screen so that it passes through the center marks. The H line should be at the same height as the fog light bulb center marks of the fog lights.
V LH Line, V RH Line (Center mark position of left-hand (LH) and right-hand (RH) fog lights):
Draw two vertical lines so that they intersect the H line at each center mark (aligned with the center of the fog light bulbs).
| 6. INSPECT FOG LIGHT AIMING |
Cover the fog light or disconnect the connector of the fog light on the opposite side to prevent light from the fog light that is not being inspected from affecting the fog light aiming inspection.
Start the engine.
Turn on the fog lights and check if the upper edge of the hot zone for each fog light matches the upper edge as shown in the illustration (except Taiwan).

Turn on the fog lights and check if the upper edge of the hot zone for each fog light matches the upper edge as shown in the illustration (for Taiwan).

| 7. ADJUST FOG LIGHT AIMING |
![]() |
Adjust the aim vertically:
Adjust the aim of each fog light to the specified range by turning each aiming screw with a screwdriver.
| *1 | Aiming Screw |