Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER

FRONT BUMPER > INSTALLATION

for Preparation Click here



1. INSTALL FRONT BUMPER ASSEMBLY
  1. w/ Headlight Cleaner System:

    1. Connect the headlight cleaner hose.

  1. Connect the connector.



    B294737
  1. Install the front bumper assembly as shown in the illustration.



    B294735
  1. Engage the 3 claws to install the front bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. w/ Front Spoiler:

    1. Engage the 2 guides and install the front spoiler cover.

    2. Install the 2 clips and 2 screws.

  1. Install the 7 clips.

  1. Install the 2 bolts and 4 screws.

  1. Install the screw.

    HINT:
    Use the same procedure for the RH side and LH side.



    B228432E05
  1. Install the pin hold clip.
    Text in Illustration 
    *a
    Correct
    *b
    Incorrect

    NOTICE:
    Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is vertical.

    HINT:
    Use the same procedure for the RH side and LH side.



2. INSTALL RADIATOR SUPPORT OPENING COVER
  1. Engage the 2 claws and install the radiator support opening cover.

  1. Install the 3 clips.



3. ADD WASHER FLUID
  1. Add washer fluid to the washer jar.



4. ADJUST FOG LIGHT AIMING
(Click here)