Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER

REAR BUMPER > REMOVAL

for Preparation Click here



1. REMOVE REAR BUMPER ASSEMBLY


    B228475E01
  1. Put protective tape around the rear bumper assembly.
    Text in Illustration 
    *1
    Protective Tape



    B228476
  1. Remove the 2 screws and 2 rear bumper upper stoppers.



    B228477
  1. Using a clip remover, remove the 9 clips.

  1. Remove the nut.



    B228478
  1. Remove the screw.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Disengage the claw.

    HINT:
    Use the same procedure for the RH side and LH side.



    B228479
  1. Disengage the 5 claws.

    HINT:
    Use the same procedure for the RH side and LH side.



    B228481
  1. Disengage the 4 claws and remove the rear bumper assembly as shown in the illustration.