Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR (for Front Side)

WASHER MOTOR (for Front Side) > INSTALLATION

for Preparation Click here



1. INSTALL FRONT WASHER MOTOR AND PUMP ASSEMBLY


    E187039
  1. Install the windshield washer motor and pump assembly.

  1. Connect the connector.

  1. Connect the washer hose.



2. ADD WASHER FLUID
  1. Add washer fluid to the washer jar.



3. INSTALL FRONT FENDER LINER RH


    E187036
  1. Install a new grommet and the 4 screws.

  1. Install the 10 clips.



    E187037E01
  1. Install the pin hold clip as shown in the illustration.
    Text in Illustration 
    *1
    Correct
    *2
    Incorrect

    NOTICE:
    Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is vertical.



4. INSTALL FRONT WHEEL RH

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }