FRONT SIDE FIX WINDOW GLASS > REMOVAL |
| 1. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP |
Remove the front part of the front door opening trim weatherstrip to the extent that allows removal of the front pillar garnish.
| 2. REMOVE FRONT PILLAR GARNISH |
![]() |
When removing the front pillar garnish LH, cover the shaded part in the illustration with a piece of cloth so that the interior parts will not be damaged.
![]() |
Pull the upper part of the garnish toward the inside of the cabin and disengage the 2 clips.
| *1 | Front Pillar Garnish Clip |
![]() |
Turn the end of the front pillar garnish clip 90° with needle-nosed pliers and remove it from the front pillar garnish LH.
| *1 | Protective Tape |
Disengage the 3 guides.
![]() |
Disengage the claw while pressing the shaded part in the illustration in the direction indicated by the arrow (1).
Remove the front pillar garnish LH by pulling it in the direction indicated by the arrow (2) in the illustration.
![]() |
Protect the curtain shield airbag assembly.
| *1 | Adhesive Tape |
| *2 | Protective Cover |
| *3 | Curtain Shield Airbag Assembly |
Cover the airbag with a cloth or piece of nylon and secure the ends of the cover with tape as shown in the illustration.
| 3. REMOVE FRONT PILLAR GARNISH CORNER PIECE |
![]() |
Disengage the 3 claws and front pillar garnish corner piece LH as shown in the illustration.
| 4. REMOVE FRONT SIDE FIX WINDOW ASSEMBLY |
![]() |
Apply protective tape to the installation position of the front side fix window assembly on the vehicle body.
| *1 | Protective Tape |
![]() |
Place matchmarks on the front side fix window assembly and vehicle body on the locations indicated in the illustration.
| *1 | Matchmark |
![]() |
Cut off the clip at the location shown in the illustration.
| *a | Cut Off |
![]() |
Pass a piano wire between the interior vehicle body and glass from the interior as shown in the illustration.
| *1 | Piano Wire |
| *2 | Front Fender Extension |
Tie both wire ends to wooden blocks or similar objects that can serve as handles.
Cut off the adhesive by pulling the piano wire around the front side fix window assembly.
![]() |
Disengage the 2 clips.
Using suction cups, remove the glass.
| 5. CLEAN VEHICLE BODY |
![]() |
Clean and shape the contact surfaces of the vehicle body.
| *1 | Adhesive |
| *2 | Vehicle Body |
Using a knife, cut away excess adhesive on the contact surfaces of the vehicle body as shown in the illustration.
Clean the contact surfaces of the vehicle body with a piece of cloth saturated with cleaner.