Home › Vehicle Interior › HEATING / AIR CONDITIONING › AMBIENT TEMPERATURE SENSOR

AMBIENT TEMPERATURE SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL AMBIENT TEMPERATURE SENSOR


    E189065
  1. Engage the clamp to install the ambient temperature sensor.

  1. Connect the connector.



2. INSTALL FRONT BUMPER ASSEMBLY
  1. Connect the headlight cleaner hose. (w/ Headlight Cleaner System)

  1. Connect each connector.



    B228442
  1. Install the front bumper assembly as shown in the illustration.



    B228440
  1. Engage the 3 claws to install the front bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.



    B228436
  1. Engage the 2 guides and install the front spoiler cover. (w/ Front Spoiler)

  1. Install the 2 clips and 2 screws. (w/ Front Spoiler)



    B228434
  1. Install the 7 clips.

  1. Install the 2 bolts and 4 screws.



    B228433
  1. Install the screw.

    HINT:
    Use the same procedure for the RH side and LH side.



    B228432E01
  1. Install the pin hold clip.

    NOTICE:
    Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is vertical.

    HINT:
    Use the same procedure for the RH side and LH side.



3. INSTALL RADIATOR SUPPORT OPENING COVER


    B228429
  1. Engage the 2 claws and install the radiator support opening cover.

  1. Install the 3 clips.



4. ADD WINDSHIELD WASHER FLUID (w/ Headlight Cleaner System)
  1. Add washer fluid to the washer jar.



5. ADJUST FOG LIGHT AIMING

HINT:
Refer to the procedure for Adjust Fog Light Aiming (Click here).