Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY AND START SYSTEM (for Start Function)

ENTRY AND START SYSTEM (for Start Function) > CUSTOMIZE PARAMETERS

for Preparation Click here



CUSTOMIZING FUNCTION WITH INTELLIGENT TESTER

HINT:
The items in the table below can be customized.

NOTICE:
  1. When the customer requests a change in a function, first make sure that the function can be customized.
  2. Be sure to make a note of the current setting before customizing.
  3. When troubleshooting a function, first make sure that the function is set to the default setting.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menus: Utility / Customize Setting.

  5. Select the setting by referring to the table below.

    Entry & Start 
    Tester Display
    Default
    Content
    Setting
    Ignition Available Area (Entry ignition available area)
    All
    Function to choose the available area for electrical key to start the hybrid control system.
    Front or All


CUSTOMIZING FUNCTION WITH DISPLAY

HINT:
The items in the table below can be customized.

NOTICE:
  1. When the customer requests a change in a function, first make sure that the function can be customized.
  2. Be sure to make a note of the current setting before customizing.
  3. When troubleshooting a function, first make sure that the function is set to the default setting.

  1. Customizing with the multi-display (for Radio and Display Type)

    1. Turn the power switch on (IG).

    2. Enter the following menus: SETUP / Vehicle.

    3. Select the setting by referring to the table below.

      Display
      Default
      Content
      Setting
      Relevant ECU
      Entry and Start System
      On
      Function that enables or disables the entry and start system.
      On or Off
      Certification ECU (smart key ECU assembly)

  2. Customizing with the multi-display (for Navigation Receiver Type)

    1. Turn the power switch on (IG).

    2. Enter the following menus: SETUP / Vehicle / Vehicle Customization / Door Lock Settings.

    3. Select the setting by referring to the table below.

      Display
      Default
      Content
      Setting
      Relevant ECU
      Entry and Start System
      On
      Function that enables or disables the entry and start system.
      On or Off
      Certification ECU (smart key ECU assembly)


CUSTOMIZING FUNCTION WITHOUT INTELLIGENT TESTER
Performing the following procedure disables the entry and start system.

HINT:
To start the hybrid control system while the entry and start system is disabled, follow the procedure for when the key battery is low (Click here).

  1. The operation procedure is as follows:
    Precondition:
    Power switch off, driver door closed and unlocked.

    1. Push the unlock switch of the key once.

    2. Open the driver door within 5 seconds.

    3. Push the unlock switch of the key twice within 5 seconds.

    4. Close and open the driver door twice within 30 seconds.
      (Driver door: Close → Open → Close → Open)

    5. Push the unlock switch of the key twice within 5 seconds.

    6. Close and open the driver door within 30 seconds.
      (Driver door: Close → Open)

    7. Close the driver door within 5 seconds.
      When electrical key cancel is activated, the wireless door lock buzzer sounds twice.
      To return to the original condition, perform the procedure again. When the original condition is returned, the wireless door lock buzzer sounds once.