Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTELLIGENT PARKING ASSIST SYSTEM

DTC    C164E    Stop Switch Circuit Malfunction

for Preparation Click here


DESCRIPTION

This DTC is stored when the parking assist ECU receives a stop light switch assembly open signal from the brake control system via CAN communication.

DTC No.
DTC Detection Condition
Trouble Area
C164E
Open in stop light switch
Electronically controlled brake system

INSPECTION PROCEDURE

1.CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC C164E is output
    A
    DTCs are not output
    B

    HINT:
    1. The DTC is stored when a malfunction occurs in the brake control system.
    2. If troubleshooting and repair of a malfunction in the brake control system has been completed, DTC C164E will not be output again when rechecking for DTCs.
    3. If DTC C164E is output frequently, duplicate the problem symptoms and perform the inspection again, even though the DTCs are not output when rechecking for DTCs (Click here).



B
USE SIMULATION METHOD TO CHECK (Click here)
A

GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEM (Click here)