Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTELLIGENT PARKING ASSIST SYSTEM

INTELLIGENT PARKING ASSIST SYSTEM > ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit is the power source circuit to operate the parking assist ECU. The parking assist ECU controls the intelligent parking assist system.

HINT:
  1. The parking assist ECU is connected to other ECUs via CAN communication or AVC-LAN communication.
  2. If the parking assist ECU does not operate due to a power source problem, a navigation system DTC may be stored due to an AVC-LAN communication interruption.
  3. If the parking assist ECU does not operate due to a power source problem, other system DTCs may be stored due to a CAN communication interruption.


WIRING DIAGRAM


E182726E18


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - BATTERY AND BODY GROUND)
  1. Disconnect the L65 connector from the parking assist ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L65-3 (GND1) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    L65-1 (+B) - F54-3 (GND1)
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)