Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROCKER PANEL MOULDING

ROCKER PANEL MOULDING > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL HOUSE FRONT PLATE


    B229360
  1. Remove the screw.

  1. Remove the clip and rear wheel house front plate.



2. REMOVE BODY ROCKER PANEL MOULDING ASSEMBLY


    B229347E01
  1. Put protective tape around the body rocker panel moulding assembly.
    Text in Illustration 
    *1
    Protective Tape



    B229348
  1. Remove the 2 screws.



    B229350
  1. Remove the screw.



    B229349
  1. Remove the screw.



    B229351
  1. Remove the screw.



    B229352E01
  1. Remove the 4 side mudguard retainers and 4 No. 2 side mudguard retainers.
    Text in Illustration 
    *1
    No. 2 Side Mudguard Retainer
    *2
    Side Mudguard Retainer



    B229353
  1. Disengage the 9 clips to remove the body rocker panel moulding assembly.

  1. Remove the 9 clips (rocker panel moulding clip).