Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ELECTRICAL KEY OSCILLATOR (for Center Floor)

ELECTRICAL KEY OSCILLATOR (for Center Floor) > INSTALLATION

for Preparation Click here



1. INSTALL ELECTRICAL KEY OSCILLATOR


    B229286
  1. Connect the connector.

  1. Install the electrical key oscillator with the bolt.

    NOTICE:
    Be careful when installing the electrical key oscillator. If the oscillator is dropped, replace it with a new one.



    B229285
  1. Install the 2 clips to the floor carpet.



2. INSTALL REAR SEAT CUSHION ASSEMBLY


    B229993E01
  1. Engage the 2 guides of the seat cushion to the seatback.
    Text in Illustration 
    *1
    100 mm (3.94 in.) or less
    *2
    Guide
    *3
    Hook

  1. Engage the 2 front hooks of the seat cushion to the vehicle body.

    NOTICE:
    When installing the seat cushion, make sure that the seat belt buckle is not under the seat cushion.

    HINT:
    Confirm that the seat cushion is firmly installed.