SECURITY HORN ASSEMBLY (for Built-in Battery type) > INSTALLATION |
| 1. INSTALL THEFT WARNING SIREN ASSEMBLY |
![]() |
Connect the connector.
![]() |
Install the theft warning siren assembly with the 2 nuts.
| 2. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY RH |
| 3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH |
Engage the 7 claws and 2 clips.
Install the deck trim side panel assembly RH with the screw.

| 4. INSTALL TONNEAU COVER HOLDER CAP |
| 5. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY |
| 6. INSTALL REAR DECK TRIM COVER |
![]() |
Engage the 4 claws and 4 guides to install the rear deck trim cover.
| 7. INSTALL DECK TRIM SERVICE HOLE COVER |
![]() |
Engage the 3 guides.
Engage the 2 claws to install the deck trim service hole cover.
| 8. INSTALL REAR NO. 1 FLOOR BOARD |
![]() |
Engage the 2 claws and 2 clips.
Install the rear No. 1 floor board with the bolt.
| 9. INSTALL REAR NO. 2 FLOOR BOARD SUB-ASSEMBLY |
![]() |
Engage the claw and 2 clips to install the rear No. 2 floor board sub-assembly.
| 10. INSTALL REAR NO. 1 FLOOR BOARD SUB-ASSEMBLY |
![]() |
Engage the 2 claws and 2 clips to install the rear No. 1 floor board sub-assembly.
| 11. INSTALL REAR NO. 3 FLOOR BOARD |
![]() |
Engage the 2 guides to install the rear No. 3 floor board.
| 12. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) |
Install the tonneau cover assembly.
| 13. INSTALL REAR SIDE SEATBACK ASSEMBLY RH |
![]() |
Engage the 2 guides as shown in the illustration.
![]() |
Install the rear side seatback assembly RH with the bolt.
| 14. INSTALL REAR SEAT CUSHION ASSEMBLY |
![]() |
Engage the 2 guides of the seat cushion to the seatback.
| *1 | 100 mm (3.94 in.) or less |
| *2 | Guide |
| *3 | Hook |
Engage the 2 front hooks of the seat cushion to the vehicle body.
| 15. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH |
![]() |
Align the alignment mark (Blue) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the rear door opening trim weatherstrip LH.
| *1 | Alignment Mark (Blue) |
| 16. INSTALL REAR DOOR SCUFF PLATE RH |
| 17. INSTALL REAR DECK FLOOR BOX |
Install the rear deck floor box.
| 18. INSTALL REAR NO. 2 FLOOR BOARD |
![]() |
Engage the 3 guides <A>.
Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.