WASHER NOZZLE (for Front Side) > INSTALLATION |
| 1. INSTALL WASHER NOZZLE SUB-ASSEMBLY |
![]() |
Connect a new washer nozzle sub-assembly to the washer hose.
![]() |
Engage the 2 claws and install the washer nozzle sub-assembly as shown in the illustration.
| 2. INSPECT WASHER NOZZLE SUB-ASSEMBLY |
With the engine running, check the position that the washer fluid hits the windshield.

| Area | Measurement | Area | Measurement |
| A | 95.8 mm (3.77 in.) | B | 323.6 mm (1.06 ft.) |
| C | 161.4 mm (6.35 in.) | D | 155.7 mm (6.13 in.) |
| E | 443.7 mm (1.46 ft.) | F | 546.6 mm (1.79 ft.) |
| G | 208.2 mm (8.20 in.) | H | 82.1 mm (3.23 in.) |
| *1 | Upper Limit | *2 | Standard |
| *3 | Lower Limit | - | - |
| 3. ADJUST WASHER NOZZLE SUB-ASSEMBLY |
Select a washer nozzle so that the contact area is within the standard. Replace the washer nozzle with the selected one.

| *a | Available Washer Nozzles | *b | Washer Fluid Spray Angle |
| *c | Part Number | - | - |