Home › Vehicle Exterior › HORN › HIGH PITCHED HORN

HIGH PITCHED HORN > INSTALLATION

for Preparation Click here



1. INSTALL HIGH PITCHED HORN ASSEMBLY


    B227894
  1. Install the high pitched horn assembly with the bolt.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

  1. Connect the connector.



2. INSTALL FRONT BUMPER ASSEMBLY
  1. Connect the headlight cleaner hose. (w/ Headlight Cleaner System)

  1. Connect each connector.



    B228442
  1. Install the front bumper assembly as shown in the illustration.



    B228440
  1. Engage the 3 claws to install the front bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.



    B228436
  1. Engage the 2 guides and install the front spoiler cover. (w/ Front Spoiler)

  1. Install the 2 clips and 2 screws. (w/ Front Spoiler)



    B228434
  1. Install the 7 clips.

  1. Install the 2 bolts and 4 screws.



    B228433
  1. Install the screw.

    HINT:
    Use the same procedure for the RH side and LH side.



    B228432E01
  1. Install the pin hold clip.

    NOTICE:
    Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is vertical.

    HINT:
    Use the same procedure for the RH side and LH side.



3. INSTALL RADIATOR SUPPORT OPENING COVER


    B228429
  1. Engage the 2 claws and install the radiator support opening cover.

  1. Install the 3 clips.



4. ADD WASHER FLUID (w/ Headlight Cleaner System)
  1. Add washer fluid to the washer jar.



5. ADJUST FOG LIGHT AIMING
(Click here)