Home › Vehicle Exterior › HORN › HIGH PITCHED HORN

HIGH PITCHED HORN > REMOVAL

for Preparation Click here



1. REMOVE RADIATOR SUPPORT OPENING COVER


    B228429
  1. Remove the 3 clips.

  1. Disengage the 2 claws and remove the radiator support opening cover.



2. REMOVE FRONT BUMPER ASSEMBLY


    B228430E01
  1. Put protective tape around the front bumper assembly.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Use the same procedure for the RH side and LH side.



    B228431
  1. Using a screwdriver, turn the pins 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.



    B228433
  1. Remove the screw.

    HINT:
    Use the same procedure for the RH side and LH side.



    B228434
  1. Remove the 2 bolts and 4 screws.

  1. Using a clip remover, remove the 7 clips.



    B228436
  1. Using a clip remover, remove the 2 clips. (w/ Front Spoiler)

  1. Remove the 2 screws. (w/ Front Spoiler)

  1. Disengage the 2 guides and remove the front spoiler cover. (w/ Front Spoiler)



    B228439
  1. Disengage the 3 claws and remove the front bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Disconnect each connector.

  1. Disconnect the headlight cleaner hose and drain the washer fluid. (w/ Headlight Cleaner System)

    HINT:
    Use a container to collect the washer fluid.



    B228441
  1. Remove the front bumper assembly as shown in the illustration.



3. REMOVE HIGH PITCHED HORN ASSEMBLY


    B227894
  1. Disconnect the connector.

  1. Remove the bolt and high pitched horn assembly.