Home › Vehicle Interior › LIGHTING (INT) › GLOVE BOX LIGHT

GLOVE BOX LIGHT > REMOVAL

for Preparation Click here



1. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY


    B223452E01
  1. Using a moulding remover, slightly lift the panel at the position shown in the illustration.
    Text in Illustration 
    *a
    Lift slightly

  1. Pull the integration control and panel assembly in the direction indicated by the arrow to disengage the 6 claws.

  1. Disconnect each connector and remove the integration control and panel assembly.



2. REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    B223454
  1. Pull the lower center instrument cluster finish panel sub-assembly in the direction indicated by the arrow to disengage the 2 claws and 2 clips.



    B223455
  1. Pull the lower center instrument cluster finish panel sub-assembly in the direction indicated by the arrow to disengage the 5 claws and remove the lower center instrument cluster finish panel sub-assembly.



3. REMOVE NO. 1 SIDE DEFROSTER NOZZLE


    B223480E01
  1. Using a moulding remover, slightly lift the panel at the position shown in the illustration.
    Text in Illustration 
    *a
    Lift slightly

  1. Pull the No. 1 side defroster nozzle in the direction indicated by the arrow to disengage the 3 claws and remove the No. 1 side defroster nozzle.



4. REMOVE NO. 2 INSTRUMENT PANEL REGISTER


    B223482
  1. Pull the No. 2 instrument panel register in the direction indicated by the arrow to disengage the claw and clip.



    B223483
  1. Pull the No. 2 instrument panel register in the direction indicated by the arrow to disengage the 2 claws and remove the No. 2 instrument panel register.



5. REMOVE GLOVE COMPARTMENT DOOR
  1. Open the glove compartment door assembly.



    B223485
  1. Pull the glove compartment door in the direction indicated by the arrow to disengage the 7 claws.

  1. Pull the glove compartment door in the direction indicated by the arrow to remove the glove compartment door.



6. REMOVE GLOVE BOX LIGHT ASSEMBLY


    E189698
  1. Disconnect the connector.

  1. Using a screwdriver, disengage the 2 claws and remove the glove box light assembly.