HIGH MOUNTED STOP LIGHT ASSEMBLY > INSTALLATION |
| 1. INSTALL CENTER STOP LIGHT ASSEMBLY |
Connect the center stop light assembly connector.
![]() |
Install the center stop light assembly with the 2 screws.
| 2. INSTALL CENTER STOP LIGHT SET |
Secure the wire running through the rear spoiler assembly to the center stop light set wire harness.
![]() |
Place a cloth on the rear spoiler assembly as shown in the illustration.
| *1 | Wire Harness |
| *2 | Gasket |
| *3 | Wire |
| *4 | protective tape |
| *5 | Cloth |
Using a clip remover wrapped with protective tape, widen the space inside the rear spoiler assembly, and pull the wire to pass the center stop light set wire harness through the spoiler.
![]() |
Install the center stop light set with the 2 screws to the rear spoiler assembly.
| *1 | Wire |
Remove the wire from the old center stop light set wire harness.
| 3. INSTALL REAR SPOILER ASSEMBLY |
![]() |
Engage the 2 clips to install the rear spoiler assembly.
![]() |
Install the 5 nuts.
Connect the connector.
| 4. INSTALL BACK DOOR TRIM BOARD |
![]() |
Engage the 5 clips and 2 guides to install the back door trim board.
| 5. INSTALL BACK DOOR TRIM BOARD ASSEMBLY |
![]() |
Engage the 11 clips and 2 claws to install the back door panel trim assembly.
| 6. INSTALL BACK DOOR SIDE GARNISH LH |
![]() |
Engage the 3 clips and 2 claws to install the back door side garnish LH.
| 7. INSTALL BACK DOOR SIDE GARNISH RH |
![]() |
Engage the 3 clips and 2 claws to install the back door side garnish RH.
| 8. INSTALL UPPER BACK DOOR TRIM PANEL ASSEMBLY |
![]() |
Engage the 4 clips and 4 claws to install the upper back door trim panel assembly.