Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR

HEIGHT CONTROL SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY


    E189660
  1. Engage the guide and install the rear height control sensor sub-assembly with the 3 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the connector.



2. INSTALL REAR WHEEL

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }



3. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



4. INSTALL REAR NO. 3 FLOOR BOARD


    B227791
  1. Engage the 2 guides to install the rear No. 3 floor board.



5. INSTALL REAR DECK FLOOR BOX
  1. Install the rear deck floor box.



6. INSTALL REAR NO. 2 FLOOR BOARD


    B227788E01
  1. Engage the 3 guides <A>.

  1. Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.



7. HEIGHT CONTROL SENSOR SIGNAL INITIALIZATION
(Click here)


8. ADJUST HEADLIGHT AIMING
(Click here)