Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT LEVELING ECU

HEADLIGHT LEVELING ECU > INSTALLATION

for Preparation Click here



1. INSTALL HEADLIGHT LEVELING ECU ASSEMBLY (for LHD)


    E189662
  1. Engage the guide.

  1. Install the headlight leveling ECU assembly with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the connector.



2. INSTALL HEADLIGHT LEVELING ECU ASSEMBLY (for RHD)


    E189661
  1. Engage the guide.

  1. Install the headlight leveling ECU assembly with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the connector.



3. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY (for LHD)


    B223650E01
  1. With the glove compartment door assembly opened approximately 55° from its closed position, engage the 2 hinges horizontally.
    Text in Illustration 
    *a
    Opened Approximately 55°
    *b
    Closed

    NOTICE:
    Engaging the hinges from the top will deform the hinges. Be sure to install the glove compartment door assembly horizontally.



    B223648E01
  1. Slightly bend the stoppers (A) and (B) in the directions indicated by the arrows in the illustration and engage the stoppers to install the glove compartment door assembly.
    Text in Illustration 
    *1
    Glove Compartment Door Stopper Sub-assembly
    *2
    Stopper

  1. Engage the claw and connect the glove compartment door stopper sub-assembly.



4. INSTALL UPPER INSTRUMENT PANEL ASSEMBLY

HINT:
Refer to the procedure from Install Upper Instrument Panel Assembly (Click here).



5. HEIGHT CONTROL SENSOR SIGNAL INITIALIZATION
(Click here)


6. ADJUST HEADLIGHT AIMING
(Click here)