TURN SIGNAL FLASHER ASSEMBLY > REMOVAL |
| 1. REMOVE UPPER INSTRUMENT PANEL ASSEMBLY |
| 2. REMOVE HEADUP DISPLAY (w/ Headup Display) |
![]() |
Disconnect the connector.
Disengage the clamp.
Remove the bolt, 2 nuts and headup display.
| 3. REMOVE NO. 3 SIDE DEFROSTER NOZZLE DUCT |
![]() |
Remove the clip and No. 3 side defroster nozzle duct.
| 4. REMOVE TURN SIGNAL FLASHER ASSEMBLY (for LHD) |
![]() |
Using a screwdriver, disengage the claw.
Disconnect the connector and remove the turn signal flasher assembly.
| 5. REMOVE TURN SIGNAL FLASHER ASSEMBLY (for RHD) |
![]() |
Using a screwdriver, disengage the claw.
Disconnect the connector and remove the turn signal flasher assembly.