Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > DISASSEMBLY

for Preparation Click here



1. REMOVE REAR COMBINATION LIGHT BODY GASKET


    E189628
  1. Remove the rear combination light body gasket.

    NOTICE:
    1. Be sure to remove all the traces of the old gasket from the body.
    2. Do not reuse the removed gasket. Be sure to install a new rear combination light body gasket to prevent water ingress.



2. REMOVE REAR TURN SIGNAL LIGHT BULB


    E189629
  1. Turn the rear turn signal light bulb and rear combination light socket and wire sub-assembly in the direction indicated by the arrow shown in the illustration, and remove them as a unit.

  1. Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly.



3. REMOVE BACK-UP LIGHT BULB


    E189631
  1. Turn the back-up light bulb and rear combination light socket and wire sub-assembly in the direction indicated by the arrow shown in the illustration, and remove them as a unit.

  1. Remove the back-up light bulb from the rear combination light socket and wire sub-assembly.



4. REMOVE NO. 1 REAR FOG LIGHT BULB (w/ Rear Fog Light)


    E189737
  1. Turn the No. 1 rear fog light bulb and rear combination light socket and wire sub-assembly in the direction indicated by the arrow shown in the illustration, and remove them as a unit.

  1. Remove the No. 1 rear fog light bulb from the rear combination light socket and wire sub-assembly.



5. REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY


    E189633
  1. Turn the cap in the direction indicated by the arrow shown in the illustration and separate it.



    E189635
  1. Disconnect the connector.

  1. Disengage the clamp and remove the rear combination light socket and wire sub-assembly.



6. REMOVE REAR BUMPER UPPER RETAINER


    E189636
  1. Using a screwdriver, disengage the claw and remove the rear bumper upper retainer.



7. REMOVE REAR COMBINATION LIGHT GASKET


    E189637
  1. Remove the rear combination light gasket.

    NOTICE:
    1. Be sure to remove all the traces of the old gasket from the body.
    2. Do not reuse the removed gasket. Be sure to install a new rear combination light gasket to prevent water ingress.



8. REMOVE REAR LIGHT GUIDE


    E189638
  1. Remove the 2 rear light guides.