REAR COMBINATION LIGHT ASSEMBLY > DISASSEMBLY |
| 1. REMOVE REAR COMBINATION LIGHT BODY GASKET |
![]() |
Remove the rear combination light body gasket.
| 2. REMOVE REAR TURN SIGNAL LIGHT BULB |
![]() |
Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb in the direction indicated by the arrow shown in the illustration and disconnect them as a unit.
Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly.
| 3. REMOVE BACK-UP LIGHT BULB |
![]() |
Turn the rear combination light socket and wire sub-assembly with the back-up light bulb in the direction indicated by the arrow shown in the illustration and disconnect them as a unit.
Remove the back-up light bulb from the rear combination light socket and wire sub-assembly.
| 4. REMOVE NO. 1 REAR FOG LIGHT BULB (w/ Rear Fog Light) |
for LHD:
![]() |
Turn the rear combination light socket and wire sub-assembly with the No. 1 rear fog light bulb in the direction indicated by the arrow shown in the illustration and disconnect them as a unit.
for RHD:
![]() |
Turn the rear combination light socket and wire sub-assembly with the No. 1 rear fog light bulb in the direction indicated by the arrow shown in the illustration and disconnect them as a unit.
Remove the No. 1 rear fog light bulb from the rear combination light socket and wire sub-assembly.
| 5. REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY |
![]() |
Disengage the 2 clamps.
Disconnect the connector and remove the rear combination light socket and wire sub-assembly.
| 6. REMOVE REAR BUMPER UPPER RETAINER |
![]() |
Using a screwdriver, disengage the claw and remove the rear bumper upper retainer.
| 7. REMOVE REAR COMBINATION LIGHT GASKET |
![]() |
Remove the rear combination light gasket.
| 8. REMOVE REAR COMBINATION LIGHT CLIP |
![]() |
Remove the 2 rear combination light clips.