Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > REASSEMBLY

for Preparation Click here



1. INSTALL REAR LIGHT GUIDE


    E189638
  1. Install 2 new rear light guides.



2. INSTALL REAR COMBINATION LIGHT GASKET


    E189637
  1. Install a new rear combination light gasket.



3. INSTALL REAR BUMPER UPPER RETAINER


    E189636
  1. Engage the claw and install the rear bumper upper retainer.



4. INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY


    E189635
  1. Engage the clamp.

  1. Connect the connector.



    E189634
  1. Turn the cap in the direction indicated by the arrow shown in the illustration to install the cap of the rear combination light socket and wire sub-assembly.



5. INSTALL BACK-UP LIGHT BULB
  1. Install the back-up light bulb to the rear combination light socket and wire sub-assembly.



    E189632
  1. Turn the back-up light bulb and rear combination light socket and wire sub-assembly in the direction indicated by the arrow shown in the illustration to install them as a unit.



6. INSTALL NO. 1 REAR FOG LIGHT BULB (w/ Rear Fog Light)
  1. Install the No. 1 rear fog light bulb to the rear combination light socket and wire sub-assembly.



    E189738
  1. Turn the No. 1 rear fog light bulb and rear combination light socket and wire sub-assembly in the direction indicated by the arrow shown in the illustration to install them as a unit.



7. INSTALL REAR TURN SIGNAL LIGHT BULB
  1. Install the rear turn signal light bulb to the rear combination light socket and wire sub-assembly.



    E189630
  1. Turn the rear turn signal light bulb and rear combination light socket and wire sub-assembly in the direction indicated by the arrow shown in the illustration to install them as a unit.



8. INSTALL REAR COMBINATION LIGHT BODY GASKET


    E189628
  1. Install a new rear combination light body gasket.