Home › Engine / Hybrid System › 2ZR-FXE COOLING › TEMPERATURE SWITCH

TEMPERATURE SWITCH > REMOVAL

for Preparation Click here



1. REMOVE FRONT SPOILER COVER (w/ Front Spoiler)


2. REMOVE ENGINE UNDER COVER


3. DRAIN COOLANT (for Engine)

NOTICE:
Do not remove the reservoir tank cap, cylinder block drain cock plugs and radiator drain cock plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



  1. Loosen the radiator drain cock plug and drain the coolant.


    A251110E01


    Text in Illustration 
    *1
    Reservoir Tank Cap
    *2
    Radiator Drain Cock Plug

    HINT:
    Collect the coolant in a container and dispose of it according to the local regulations.



4. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    A216065
  1. Disconnect the engine coolant temperature sensor connector.



    A216066
  1. Using a union nut wrench (19 mm), remove the engine coolant temperature sensor.

    NOTICE:
    Do not apply any excessive force to the heater pipe when removing the engine coolant temperature sensor.