EXHAUST PIPE GAS CONTROL ACTUATOR > REMOVAL |
| 1. REMOVE FRONT SPOILER COVER (w/ Front Spoiler) |
| 2. REMOVE ENGINE UNDER COVER |
| 3. DRAIN ENGINE COOLANT (for Engine) |
Loosen the radiator drain cock plug and drain the coolant.
Loosen the cylinder block drain cock plug.

| *1 | Reservoir Tank Cap | *2 | Cylinder Block Drain Cock Plug |
| *3 | Radiator Drain Cock Plug | *4 | Air Release Valve |
| 4. REMOVE EXHAUST PIPE GAS CONTROL ACTUATOR |
![]() |
Disconnect the 2 water hoses.
![]() |
Using a screwdriver with the tip taped, pry the portion indicated in the illustration to disengage the spring.
| *1 | Protective Tape |
![]() |
Remove the 3 bolts, 3 nuts, gasket and exhaust pipe gas control actuator case.
![]() |
While closing port A, apply compressed air to port B to remove the exhaust pipe gas control actuator shown in the illustration.
| *1 | Exhaust Pipe Gas Control Stopper |
| *2 | Exhaust Pipe Gas Control Actuator |
| *3 | Port A |
| *4 | Port B |