DTC B278C Lost Communication with Power Source Control |
| DTC No. | DTC Detection Condition | Trouble Area |
| B278C | No communication between the certification ECU (smart key ECU assembly) and power management control ECU for 10 seconds or more. |
|

| 1.CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - BATTERY AND BODY GROUND) |
![]() |
Disconnect the L5 and L6 power management control ECU connectors.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L5-6 (E1) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| L5-1 (AM22) - Body ground | Power switch off | 11 to 14 V |
| L6-7 (AM21) - Body ground | Power switch off | 11 to 14 V |
| *1 | Front view of wire harness connector (to Power Management Control ECU) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - POWER MANAGEMENT CONTROL ECU) |
![]() |
Disconnect the L62 certification ECU (smart key ECU assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L62-29 (LIN) - L6-11 (LIN2) | Always | Below 1 Ω |
| L62-29 (LIN) - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to Certification ECU (Smart Key ECU Assembly)) |
| *2 | Front view of wire harness connector (to Power Management Control ECU) |
|
| ||||
| OK | |
| 3.REPLACE POWER MANAGEMENT CONTROL ECU |
Replace the power management control ECU (Click here).
| NEXT | |
| 4.CHECK DTC OUTPUT |
Clear the DTC (Click here).
Recheck for DTCs.
|
| ||||
| OK | ||
| ||