Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM

DTC    P06A4-209    Sensor Reference Voltage "D" Circuit Low

DTC    P06A5-210    Sensor Reference Voltage "D" Circuit High

for Preparation Click here


DESCRIPTION

The power management control ECU (HV CPU) monitors voltage of 5 V power supply (VC) used for the sensors. If the power management control ECU (HV CPU) detects a malfunction, it will set a DTC.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P06A4
209
VC power-supply voltage is lower than 4.2 V
Power management control ECU
P06A5
210
VC power-supply voltage is higher than 5.8 V
Power management control ECU

INSPECTION PROCEDURE

1.CHECK DTC OUTPUT (HV)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

  1. Check if DTCs are output.

    Result:
    Result
    Proceed to
    P06A4-209 to P06A5-210 only is output.
    A
    Any of the following DTCs are also output.
    B


    DTC No.
    Relevant Diagnosis
    P0516-769
    Battery Temperature Sensor Circuit Low
    P0517-770
    Battery Temperature Sensor Circuit High
    P0A2C-247
    Drive Motor "A" Temperature Sensor Circuit Low
    P0A2D-249
    Drive Motor "A" Temperature Sensor Circuit High
    P0A38-257
    Generator Temperature Sensor Circuit Low
    P0A39-259
    Generator Temperature Sensor Circuit High
    P2120-152
    Throttle/Pedal Position Sensor/Switch "D" Circuit
    P2122-104
    Throttle/Pedal Position Sensor/Switch "D" Circuit Low Input
    P2123-105
    Throttle/Pedal Position Sensor/Switch "D" Circuit High Input
    P2125-153
    Throttle/Pedal Position Sensor/Switch "E" Circuit
    P2127-107
    Throttle/Pedal Position Sensor/Switch "E" Circuit Low Input
    P2128-108
    Throttle/Pedal Position Sensor/Switch "E" Circuit High Input

    HINT:
    P06A4-209 or P06A5-210 may be set due to a malfunction which also causes DTCs in the preceding table to be set. In this case, first troubleshoot the output DTCs in the preceding table. Then, perform a test to attempt to reproduce the problems, and check that no DTCs are output.



B
GO TO DTC CHART (Click here)
A

REPLACE POWER MANAGEMENT CONTROL ECU (Click here)