RADIO RECEIVER > INSTALLATION |
| 1. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY |
| 2. INSTALL EXTENSION MODULE (w/ Navigation System) |
Connect the connector to install the extension module.
Connect each connector to install the navigation wire and radio cable.
| 3. INSTALL NO. 2 RADIO BRACKET |
w/o Navigation System:
Install the No. 2 radio bracket with the 3 bolts.
w/ Navigation System:
Install the No. 2 radio bracket with the 5 bolts.
| 4. INSTALL NO. 1 RADIO BRACKET |
w/o Navigation System:
Install the No. 1 radio bracket with the 3 bolts.
w/ Navigation System:
Install the No. 1 radio bracket with the 5 bolts.
| 5. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET |
Connect each connector.
Engage the 4 claws.
Install the radio and display receiver assembly with bracket with the 4 bolts.
| 6. INSTALL UPPER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY |
![]() |
Connect the connector.
Engage the 3 claws to install the upper instrument panel finish panel sub-assembly.
| 7. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH |
Connect the connector.
Engage the 14 claws to install the instrument cluster finish panel garnish.
| 8. INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY |
![]() |
Engage the 7 claws and 2 clips to install the lower center instrument cluster finish panel sub-assembly.
| 9. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY |
![]() |
Connect each connector.
Engage the 6 claws to install the integration control and panel assembly.
| 10. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL |
| 11. INSTALL REAR NO. 3 FLOOR BOARD |
![]() |
Engage the 2 guides to install the rear No. 3 floor board.
| 12. INSTALL REAR DECK FLOOR BOX |
Install the rear deck floor box.
| 13. INSTALL REAR NO. 2 FLOOR BOARD |
![]() |
Engage the 3 guides <A>.
Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.