HAZARD WARNING SWITCH > REMOVAL |
| 1. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY |
![]() |
Using a moulding remover, slightly lift the panel at the position shown in the illustration.
| *a | Lift slightly |
Pull the integration control and panel assembly in the direction indicated by the arrow to disengage the 6 claws.
Disconnect each connector and remove the integration control and panel assembly.
| 2. REMOVE INTEGRATION CONTROL AND PANEL SUB-ASSEMBLY |
![]() |
Using a screwdriver, disengage the 6 claws and remove the integration control and panel sub-assembly.