RADIO RECEIVER > REMOVAL |
| 1. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY |
![]() |
Using a moulding remover, slightly lift the panel at the position shown in the illustration.
| *a | Lift slightly |
Pull the integration control and panel assembly in the direction indicated by the arrow to disengage the 6 claws.
Disconnect each connector and remove the integration control and panel assembly.
| 2. REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY |
![]() |
Pull the lower center instrument cluster finish panel sub-assembly in the direction indicated by the arrow to disengage the 2 claws and 2 clips.
![]() |
Pull the lower center instrument cluster finish panel sub-assembly in the direction indicated by the arrow to disengage the 5 claws and remove the lower center instrument cluster finish panel sub-assembly.
| 3. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH |
Disengage the 14 claws.
Disconnect the connector and remove the instrument cluster finish panel garnish.

| 4. REMOVE UPPER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY |
![]() |
Disengage the 3 claws.
Disconnect the connector and remove the upper instrument panel finish panel sub-assembly.
| 5. REMOVE RADIO RECEIVER WITH BRACKET |
![]() |
Remove the 4 bolts.
![]() |
Disengage the 4 claws as shown in the illustration.
Disconnect each connector and remove the radio receiver with bracket.
| 6. REMOVE NO. 1 RADIO BRACKET |
![]() |
Remove the 4 bolts and No. 1 radio bracket.
| 7. REMOVE NO. 2 RADIO BRACKET |
![]() |
Remove the 4 bolts and No. 2 radio bracket.
| 8. REMOVE RADIO RECEIVER ASSEMBLY |