Home › Audio / Visual / Telematics › AUDIO / VIDEO › FRONT DOOR SPEAKER

FRONT DOOR SPEAKER > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG


    B228655
  1. Using a moulding remover, disengage the 3 claws and remove the front door inside handle bezel plug.



2. REMOVE ASSIST GRIP COVER


    B228659
  1. Using a moulding remover, disengage the 6 claws, 2 clips and 3 guides, and remove the assist grip cover.



3. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)


    B228663
  1. Disengage the 7 claws and 3 guides.

  1. Disconnect the connector and remove the power window regulator master switch assembly with front door armrest base panel.



4. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)


    B232008
  1. Disengage the 7 claws and 3 guides.

  1. Disconnect the connector and remove the power window regulator switch assembly with front door armrest base panel.



5. REMOVE DOOR ARMREST COVER


    B228665
  1. Remove the door armrest cover.



6. REMOVE COURTESY LIGHT ASSEMBLY


    E189695E01
  1. Using a moulding remover, disengage the claw.

  1. Disconnect the connector and remove the courtesy light assembly.



7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    B228667E01
  1. Put protective tape around the front door panel.
    Text in Illustration 
    *1
    Protective Tape



    B228669
  1. Remove the 2 screws.

  1. Using a clip remover, disengage the 9 clips.

  1. Pull out the front door trim board sub-assembly in the direction indicated by the arrow in the illustration.

  1. Raise the front door trim board sub-assembly and remove the front door trim board sub-assembly together with the front door inner glass weatherstrip.



    B228673
  1. Disengage the 2 claws and disconnect the front door inside handle sub-assembly.



8. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY


    E188466
  1. Disconnect the connector.

  1. Using a drill bit with a diameter of less than 4 mm (0.158 in.), drill out the 3 rivet heads and remove the front No. 1 speaker assembly.

    NOTICE:
    1. Do not touch the cone part of the speaker.
    2. Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.
    3. Be careful as the cut rivet will be very hot.

  1. Continue drilling and push out the remaining rivet fragments.

  1. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.