REAR DOOR SPEAKER > REMOVAL |
| 1. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG |
![]() |
Using a moulding remover, disengage the 3 claws and remove the rear door inside handle bezel plug.
| 2. REMOVE DOOR ASSIST GRIP COVER |
![]() |
Using a moulding remover, disengage the 6 claws, 2 clips and 3 guides, and remove the door assist grip cover.
| 3. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL |
![]() |
Disengage the 7 claws and 2 guides.
Disconnect the connector and remove the rear power window regulator switch assembly with rear door armrest base panel.
| 4. REMOVE REAR DOOR ARMREST COVER |
![]() |
Remove the rear door armrest cover.
| 5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY |
![]() |
Put protective tape around the rear door panel.
| *1 | Protective Tape |
![]() |
Remove the 2 screws.
Using a clip remover, disengage the 8 clips.
Pull out the rear door trim board sub-assembly in the direction indicated by the arrow in the illustration.
Raise the rear door trim board sub-assembly and remove the rear door trim board sub-assembly together with the rear door inner glass weatherstrip.
![]() |
Disengage the 2 claws and disconnect the rear door inside handle sub-assembly.
for 8 Speakers:
Disconnect the connector.
| 6. REMOVE REAR NO. 2 SPEAKER ASSEMBLY (for 8 Speakers) |
![]() |
Remove the 2 screws and rear No. 2 speaker assembly.
| 7. REMOVE REAR SPEAKER ASSEMBLY |
![]() |
Disconnect the connector.
Using a drill bit with a diameter of less than 4 mm (0.158 in.), drill out the 3 rivet heads and remove the rear speaker assembly.
Continue drilling and push out the remaining rivet fragments.
Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.